Why Prodecoder HU66 GEN 1?
Prodecoder HU66 Gen 1 is mainly used on the ignition, because it covers wide range in terms of years – models from 1998 until 2015. On door it works on relatively old models – 1998 – 2004. The models from 2005 to 215 (only dorr) are covered by Prodecoder Gen 2/3. Prodecoder HU66 GEN 1 is a mechanical tool that opens very fast lock type HU66 Gen 1. In order to be successful with the opening, a specific procedure must be followed.
Below in this description you will find General Video Instructions that show step by step the opening methodology. One of the greatest challenges that every user faces is how to distinguish between Gen 1 and Gen 2/6. For this reason we provide a tester key. When the decoder is used according to the instructions, this can become an indispensable tool for every professional locksmith not only in the opening, but also in the decoding. After decoded, the user can make a duplicate key. Very easy to learn. Extremely durable.
WD-40? Yes, it is important
Always apply WD40 before inserting the decoders in the locks. WD-40 loosens rust-to-metal bonds and frees stuck, frozen or rusted metal parts. With WD-40 you help the pins move inside the lock cylinder - this leads to better performance
Three main wheels, easy to remember
Step 4. Opening procedure
The most important part is how strong your tension is (on the tension wheel). If its too weak – the lock won’t open or it will open very slow. If the tension is too strong – you may break the tool or risk of tool deformation.
Turn the tension wheel to the LEFT (keep holding it) and then turn the turbo wheel to the left until you reach the 1st stop point (we have 1 2 3 4 stop points engraved on the the gate) and return the turbo wheel to the right in its original position. Turn the tension wheel to the RIGHT (keep holding it) and then turn the turbo wheel to the left until you reach the 1st stop point (we have 1 2 3 4 stop points engraved on the the gate) and return the turbo wheel to the right in its original position. Repeat this procedure 15-50 times on stop point 1, 15-20 on stop point 2 and 15-20 times of stop point 3 and on point 4. This is what we call “progressive opening”.
Do not rush the tool, the point here is not to reach point 3. When the prodecoder is turned to the opening position, stay in this position and turn the turbo wheel to the stop point on the gate wheel (the opening point) Juggle a little bit Turn to the other side