Toyota Emergency Start & Key Programmer

4,000 

Supports All models with smart keys from 2009 to 2017

The device has two modes:

1. Emergency start

2. Key programming

Before beginning any of the procedures it is important to wake the car up. This is done by pressing the start button a few times and turning the headlights on and off.

Mode 1: Emergency start

The switches have to be as follows: 1.ON 2.OFF 3.ON 4.OFF 5.ON 6.OFF 7.ON 8.OFF

The device needs to be plugged in and you need to look at the LED. If it is flashing RED, you need to press the start button with the transponder emulator.
If it is solid RED, you need to touch the start button with the transponder emulator.

Mode 2: Key programming

Switch 1 is ALWAYS ON. Then depending on the number of keys you want to program, slide the corresponding switch to the ON position (for example for 3 keys, SWITCH 3 should be set to ON).

The device needs to be plugged in and you need to look at the LED. If it is flashing RED, you need to press the start button with the transponder emulator.

If it is solid RED, you need to touch the start button with the transponder emulator.

If the LED is solid GREEN, you need to touch the new key that you want to program to the start button so that it can be programmed to the car.
Usually the car makes a sound.

Reviews

There are no reviews yet.

Be the first to review “Toyota Emergency Start & Key Programmer”

Your email address will not be published. Required fields are marked *